Seeker's ESB & Pre-Pro 3 Armor Build Up.

When you pin the wookie braids on, use the safety pin from underneath inside of the vest. It won't show any more than it needs to on the outside then.
 
Wow. That collar attaching method is awesome. As someone who has a miniscule amount of experience in that kind of thing. What did you use and how did you make it so I could give it a go?
 
Awesome! Simply awesome!

I had considered doing something similar, but just a shoulders up display PP3--along the lines of what the Sideshow bust should have been but wasn't . . .
 
Thanks guys.

Here's how I attach my collar to the my backplate.

6331247965_63651bbeb9_b.jpg


6332001314_949a735702_b.jpg


6332001234_6dba6f606a_b.jpg

That is a great solution with connecting the collar and back plate. where could one find that part?
 
I needed construct that myself. Its very easy to make. just get an aluminim flat bar, then drill some holes at the screws through it and jb weld it. thats what i did. :D
 
Awesome display!! totally looking the part... :eek:
I too also like the way you have attached the back n collar parts. Look forward to the progress.
 
Last edited by a moderator:
Awesome display!! totally looking the part... :eek:
I too also like the way you have attached the back n collar parts. Look forward to the progress.

you should make those available for people Mojo! you could probably whip those out in no time.
 
Last edited by a moderator:
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top