Scrtch built shin tools.. From WOF templates

tbone9600

Active Hunter
Just finished up my shin tools. I used sintra for most of them with the exception of the JP tool. I used a dow rod, a plastic test tube, and the plastic tube from the center of an adding machine paper roll for it... and some bondo. Here they are.

Shin Tools 001sm.JPG


Shin Tools 006sm.JPG


Shin Tools 008sm.JPG


ShinTools009sm.JPG


ShinTools010sm.JPG
 
Those look great! The weathering really makes them stand out. Glad to be of assistance. So how long did it take you to build them?

Alan
 
That's a grand job you have done there ! I've been using the same templates and personally want to thank wizardofflight myself big thank you Mr Sinclair o_O
 
This thread is more than 5 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top