screen accurate jetpack harness for my mow jetpack

sgt kal

New Hunter
jetpackharness020-1.jpg
[/IMG] HI everbody , here is some pictures of my jetpack harness i have built for my jetpack.
jetpackharness002.jpg
[/IMG]
jetpackharness014.jpg
[/IMG]
pictures407.jpg
[/IMG] I built it using the info on the offical jetpack harness thread , it wasn't easy but i'm pretty sure it close to real one. Here some pictures of the frame and some of the parts.
pictures369.jpg
[/IMG]
jetpackharness.jpg
[/IMG]
pictures422.jpg
[/IMG]
pictures404.jpg
[/IMG]
pictures397.jpg
[/IMG] I used aluminum for the tube , i bent using a custom die to form the 3.5 inside space between the tubes. i also bent upper part of the tube foward , like the original. the cross bracket where made on a custom made rollform machine , that made both p shape ends at the same time. all the parts i had to make forming dies for , some parts multistage dies. the cross bar i used a flexible piece of stainless steel , so it could conform to the curve of the jetpack ,looking closly at the original harness frame the cross bar was about thickness of the secondary bracket on the frame . I used stainless steel for almost everything except the tube , diamond shape rings ( the diamond shape rings were alot easier to form using aluminum). The lower clip is a little different then original , it consist of three parts ,the clip , locking plate and a spacer plate. the locking plate locks the crossbar into it and spacer helps prevent the edges of the crossbar from gouging into the jetpack. Heres some pictures of the clip.
jetpackharness028.jpg
[/IMG]
jetpackharness004.jpg
[/IMG] Thanks for checking it out ,
 
This thread is more than 11 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top