scratchbuilding the studs..measurements?

Luis

Hunter
Hi I would like to scratchbuild the shoulder studs of boba.. would anyone know the exact measurements?

Thanks very much!
 
If I recall correctly, the studs are the same size as a normal keyboard key (and the originals might be made from keyboard keys).
 
If I recall correctly, the studs are the same size as a normal keyboard key (and the originals might be made from keyboard keys).

Thanks RF, I managed to score some keys off an old keyboard.. But It doesnt seem right.. the sides have to much of a sloped angle.. plus the bottom is uneven.. For wrist angle purposes when typing i guess.

I have a block of resin lying around from a previous recast of a m38 scope.. So i guess I could use that.. So I really can't use the keyboard keys that I have as a reference..

Anyone willing to take measurements of their studs? L x W x H?

Thanks!
 
I was thinking the same thing about the angle of the keys...u need to find the perfectly square keys,on a non sloped keyboard or adding machine
 
Could you guys give me measurements of your studs? If it's not too much to ask :) I'll just mold them out of resin.
 
If they turn out good, I'd be interested in 2 studs for my cod->butt connection. :)

That is.. if you think of doing more than just for yourself.
 
This thread is more than 12 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top