Scratch-built ESB blaster...

Reverend Scapegoat

Active Hunter
"Rush-job-tastic", this, but I might as well stick up some pics anyway :)

Ingredients:
1 old Colt Python blank-firer ( Broken )
1 piece MDF ( About 1.5cm thick )
1 piece plastic pipe, white and roughly 4cm diameter
Silver paint
Milliput
A small bolt

BRB with pics :)
 
so you are going to 'macgyver' a esb blaster?? Look forward to seeing this...
Reverend Scapegoat said:
Ingredients:
1 old Colt Python blank-firer ( Broken )
1 piece MDF ( About 1.5cm thick )
1 piece plastic pipe, white and roughly 4cm diameter
Silver paint
Milliput
A small bolt

BRB with pics :)
 
Meh.
I'm really running out of time, and have got way more to do at the new house than I thought - So this has been sped up ( Since I only plan to carry it for a little while on hallowe'en then ditch it. )

Also, my epoxy seems to have gone bad somehow.
Cue...
Electrician's tape!

crapblaster.jpg


Needs some more paint, too... Not QUITE done with it yet :)
 
:D actually... I think that looks pretty darn cool!!

the base gun looks pretty rigid.. something that's in a high level of importance to me since my own freakin thing broke... :p
 
Can't find any brown paint for the stock!!
Black non-slip, I think... It's textured, so should look good. Then another layer, I'll TRY to mix in some red, see if it'll work.
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top