scratch build jet pack.....progress

Tom -enough with the sage advice already; get some RTV and get the run going already!

lol joking mate - love the transition from pre-sanding to post-sanding.
 
Last edited by a moderator:
i got half of it in urathane rubber as we speak. i hope to have the first one casted be the end of next week, but it is getting really cold so that does not help with the fiberglass and gelcoat.

oh how i wish i had a heated shop.
 
Last edited by a moderator:
u want cold and miserable - u should look outside my window at the moment. no one does miserable as well as the british!

man - no heated shop and working through winter..... brave man, brave man.

btw email replied mate

Nate
 
Last edited by a moderator:
this project was a total failure , thanks for playing.


i destroyed the master molding it. and destroyed the mold trying to cast it. and destroyed the casting after i saw how out of wack the casting came out of the mold like.

**** it!
 
Last edited by a moderator:
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top