ROTJ Jet Pack

woodman

Active Hunter
ROTJ Jetpack

Wanted to share my first JP with the board. I used 1/4" foamcore
board for the main body, PVC pipe for the fuel tanks, and lots of
Bondo. I am a woodworker so I used a lathe to turn all of the round stuff
like the end caps, thrusters, and the missle. I also used alumilite resin to make some small details. I used WOF's templates and I must say he is an
asset to this board, anyone who provides for free what he could obviously
sell for $$ is a stand up guy! Let me tell you is sure does take alot of hand sanding to intergrate those fuel tanks smoothly! Hope the JP is up to snuff! I know it's off a little bit but I still like it.:D

PS. Feel free to pick it apart criticism is the fuel that drives us to do better!
 
sorry the pics didn't go through here they are.

DSCF0074.JPG


DSCF0075.JPG


DSCF0077.JPG
 
Last edited by a moderator:
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top