rotj jet pack

teabo

Hunter
rotj jetpack

do i need to raise it more or does it look low
100_0737.jpg

100_0736.jpg
 
Waaay too low... i had the same problem... The harness creeps up and pulls it back while wearing it...

What you need to do it only have about 1-1.5 inches of the jp straps showing to begin with before putting the pack on... Or literally just the buckle clip. Gravity will take care of the rest and pull the pack down to its proper height..

But its supposed to sit on the upper back, so that the peak of the rounded part on the pack is higher slightly or completely level with the raised collar on the back plate...

Hope that helps...
 
Last edited by a moderator:
rasie it should be 1-2 inch hanging off. but it depends on where you have it connected on the pack. it looks pretty high also i can see the loop on the JP, so maybe try an inch?
 
Last edited by a moderator:
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top