RotJ gauntlet buildup

the real boba gauntlets don't use hinges at all... just velcro. the trouble with that is that the constant flexing results in paint chipping / cracking.
 
... and i noticed that i put the darts in crooked. with epoxy putty. getting those back out was special. the neat thing is that the putty i used to reinstall them is mixed with my own blood. ok, so that's actually creepy. but i cut myself and my fingers were too gross to even try to stop it.
 
Blood, sweat, and tears; that's the way to get ahead in this hobby...

I know, I almost completely lost my left middle finger to my reinforced Dremel cutting wheel while working on my ROTJ EE-3...
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top