I'm not sure what type of helmet it is, I impulse bought it on ebay without doing much research until after. It's larger than my old don post helmet though. The stalk did come with the helmet.
The stalk is resin. The ear cap fits on the helmet fine, the stalk is just too thick. It does fit into the RF top well though. I'll attempt to taper it without sanding the entire side of the stalk.
Resin = snap
Not always. It really depends on how you handle your helmet and also what your doing with it. I had a resin stalk for 2yrs before i switched it to a metal one and i never broke mine. Also if its a display helmet, it really wont matter much. Is it recommend to get a metal stalk, sure, but you definitely dont NEED it. You just need to be a little extra careful with a resin stalk is all.
Not always. It really depends on how you handle your helmet and also what your doing with it. I had a resin stalk for 2yrs before i switched it to a metal one and i never broke mine. Also if its a display helmet, it really wont matter much. Is it recommend to get a metal stalk, sure, but you definitely dont NEED it. You just need to be a little extra careful with a resin stalk is all.
Well... I accidentally broke the stalk. Everything was together and working then I dropped the helmet and it's now in three pieces. Anyone know where I can get a metal one? I'll need a new RF top as well because this one was jb welded in. Ugh... I'm off to an awesome start on this project.
LOU!!!!!!!!!!!!!!!