Resin blaster handle connector question???

mcabrera1275

Active Hunter
I am concerned with the durability of the part on the handle that connects the gun handle to the butt of the rifle. This "D" shaped piece seems a little thin compared to the weight of the butt and main rifle, and I was wondering if anyone had problems of their "D" connector breaking.

Mine is resin as well, so that is why I am concerned of it breaking. Is there a metal version of this part readily available?
 
i got ahold of a piece of 1/4 inch alluminum and traced the "d" shape metal piece , then went at it with a jig saw . you might try that to connect the two pieces together .
 

mcabrera1275 wrote:

I am concerned with the durability of the part on the handle that connects the gun handle to the butt of the rifle. This "D" shaped piece seems a little thin compared to the weight of the butt and main rifle, and I was wondering if anyone had problems of their "D" connector breaking.

Mine is resin as well, so that is why I am concerned of it breaking. Is there a metal version of this part readily available?

MB has a cast aluminum "D" connector with his rifle kit, he may sell one seperatly.

Lynn
 
I made mine connecting piece from 1/8" think aluminum, and then glued them together with JB Weld to make them 1/4" thick. This makes it a little easier to work with when cutting the pieces...only thing is you have to do it twice ;)
 
This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top