Reinforcing Vacu-Formed Gauntlets with Fiberglass

E2K13

Well-Known Hunter
I just reinforced my set of styrene gauntlets with Fiberglass under the instruction of MARROW_SUN and a friend of min Bobby C. The process worked out great and I would like to share it with you all especially those that have never done FG.

If you have a set of Vacu-formed gauntlets, odds are that they are made from styrene, ABS or sintra and will warp with heat increases so you cannot use a urethane resin for the FG you need to use an Epoxy Resin. Preferably a cold cure but all of them have thermographic properties.
I found a Fiberglass Supply house here in Detroit that I was able to get my supplies from. First, it is important to note that you should score the insides of your gauntlets or"key" them as it is so called with an 80 grit sandpaper before laying the FG.
I used a 1-3 ratio Epoxy that is 1 part hardner to 3 parts resin. I just measured them out in cheap dollar store measuring cups. I mixed them in a large paper cup and used a glue brush which looks like a small paintbrush with a metal handle to paint the epoxy into the inside of the gauntlets. They are cheap. Cost like $1.50 for 5 of them.
Now, you only have about 15 minutes of workable time so you have to be sort of quick. I already had my Fiberglass cloth cut into strips so that I could lay them overtop of the epoxy. You then take the glue brush and sort of use a tapping motion to get the epoxy to soak into the cloth. Paint a little epoxy over the top of the cloth as well making sure you get all the little nooks and crannies. You don't want air bubbles so even after the epoxy sets up in your cup, the epoxy on the cloth will be tacky and still setting. spend the rest of the time tapping down the bubbles with a popsicle stick and or the brush until it sets up. Let them sit overnight so that they are nice and hard and then you can trim it all up.
Hope this helps.
Mine definately exceeded my own expectations and have a slight flex because I only used 1 layer of the cloth.

~Eddie
 
I would like to add, wear a breathing mask, and rubber gloves, this stuff is very harmful to your health and can induce seizures.

Good tutoral though, I just reinforced mine with wal-mart fiberglass cloth and the cold resin in the can
 
Yea, I wish I would have added that one too Cal. Thanks!
Also, I did mine outside in the drive way so that there was alot of ventilation. THe slight breeze helped. LOL
 
Also, epoxy resins do not desolve the styrene binder in chop-strand matt, like polyester resins do. So if you try to use matt, instead of cloth, with the epoxy, you'll need to shred it up first. :)
 
That was one of the reasons I went with the FG Cloth. It was easier to lay then the shreded Strand Mat.
 
GOod call CAL on the ventilation comment. Fortunately most of the work I have done has been in an open shop, but the ONE time that it wasn't, I had some serious fun, er, problems. Those fumes are BAD!

On an added note...if you have something like a pocket, or crevise that needs to be filled and reinforced, chop up a small section of the cloth and mix with the resin, pour it, and let it set. Then you can lay the cloth layer.

Darren
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top