Reinforcing Sintra?

I Scratch built Knee Armor from Sintra, Pieces seem breakable
any suggestions on any type of (fiberglass type) reinforcment
I can spray/brush on to make my pieces more wear and tear / dropping
Durable?
 
I would suggest making the knee armor one peice.That is how I do my metal ones.It is just more durable that way.
I never liked the idea of 3 seperate parts.
 
Put a layer of bondo behind it. Super Glue works unimaginably well for Sintra, so if anything breaks, it can be fixed in as long as it takes to get the bottle of super glue out.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top