Reinforcing a jet pack

Mando soldier

New Hunter
Reinforcing a jetpack

Could not find this in any other thread, so does anyone have an idea on how to reinforce a hollow plastic jet pack? pictures of what it looks like or how you completed it would be greatly appreciated.
 
Somethin to think about...don't mix the resin too "hot" it makes heat when it cures, dont want to use too much too soon and start softening the plastic.
 
Last edited by a moderator:
I'm actually in the process of building my plastic one. Instead of resin or fiberglass, I'm gonna use pieces of balsa wood stacked. The shells of my two piece jet pack will snuggly fit over the wood. It will either be glued or screwed together. If i screw it together, I will cover the holes with epoxy putty.
 
Last edited by a moderator:
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top