Problem with my Shackman Lights

TBone

Active Hunter
I haven't been on a lot lately...but I think Shackman may not be frequenting this board very often anymore. My problem is the battery connector totally pulled off of the board for my chest lights and I have no clue where the leads need to be resoldered on the board.

Can someone take a picture of their lights, specifically where the power and ground leads connect to the board and send it to me?
Thanks,
 
I have the same one you do, when I get back from the F4, I will take a few detailed shots, unless someone beats me to it.
 
I just got this one last year right after DCon. So, its about 6-9 mos old. I'm not sure if its before or after the redesign.
 
I hope this helps, there is alot of glue around the leads so you cant really see where the go to, Do you know how to solder? Just put a battery on the lead and put them on the terminals around that area untill it starts working. Or mail it to shackman :)
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top