Prepping and painting FettPride v3 ROTJ armor?

corey2314

New Hunter
Hey guys, I've done a bit of searching and found a lot of info on ESB armor paints, but not so much on ROTJ armor. Does anyone have a list of any kind of paints for painting the chest, shoulder, knees, etc for a set of ROTJ?

Also, I've read a bit about prepping the armor, would I be better off using sandpaper or steel wool? What grade of each should be used so I don't scratch it all up? Thanks guys.

-Corey
 
Yeah, I saw the thread mentioned and sticky. I was unaware that AoSW was the same scheme as ROTJ as far as the body armor. I think I'm gonna try my hand at airbrushing as well. Will any type of steel wool work, or is there a certain kind I should get?
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top