General Polycarbonate visors

J

jangorenn

New Hunter
Hey guys, ran into a bit of an issue. just picked up a couple dark green visors from RJ Safety. But I haven't a clue on how to cut them to fit my bucket. If anyone has any suggestions on doing that, I would appreciate it very much. signed can't cut it!
 
I cut mine with a cutoff wheel in a die grinder. Do you have a dremel? Need one and a cutoff wheel(s) and sanding drum attachments or rotary files to get the transition looking decent.
 
Do what syllander said but it helps to start with doing a cardboard template from the inside of your helmet first.
Be sure to wear goggles while cutting the visor, the dremel will basicly melt some of the material and it hurts like a MF to get in the eyes.
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top