Plastic Question

Beowulf

Active Hunter
Hi all,

I know that the standard plastic used is Sintra, but i have been offered a couple of sheets of Coroplast, i dont know anything about it and was wondering if its close to Sintra(PVC plastic) or is it completly differnt and wont work for making armor? Any help or advice would be appreciated

Thanks,
Wulf
 
The coroplast I have seen wouldn't be suitable for Fett armor. The reason everyone uses sintra is because it is easy to thermoform & shape. I don't think coroplast has these same properties & you would spend a lot of time filling the corrugated edges.
 
Thanks all

I recived an email from the supplier and once i had explained to him what i wanted to do with it, they said that it was not even close to what i was looking for. So i guess i have to keep looking for someone in the area who will sell me some sintra

Thanks again
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top