Official Jet Pack Greeblies

  • Thread starter Migrate from As You Wish
  • Start date
I've done with my Jet Pack, and also painting the greeblies to glue underneath the Jet Pack (Pre-Prod pics). I know that I'm doing a mix of pre-past (pre-pro), past (ESB) and present (ROTJ) looking costume, but more inclined to the ROTJ Fett.

Anyways, I got all my Greeblies painted and ready to install, but as you can see in these pics, there's barely space to install them, which there's suppose to be an almost 2 inches extra from the exhaust grill to the bottom/back of the jet pack, and I have around an inch in between.

WMLQL-Jet%20Pack0015.png


LUHQT-Jet%20Pack0016.png


Now, I'm thinking about leaving it as it is (accurate ROTJ-MoM) or add the greeblies (custom Jet Pack) if still some of the greeblies don't fit, but install the ones that does in the sides.

Robert
 
Last edited by a moderator:
Lynn, I agree, and I love it, cause you have one really accurate with the Pre-Prod. pack. But compare the pics between yours and mine, and notice the space in between the exhaust grill and the bottom part (where you have one of the connectors)...both packs are different.

LynnsJet%20Pack.png


LUHQT-Jet%20Pack0016.png


That's my BIG question now. Cause I have all the greeblies ready to install, but "space-wise" is telling me...NO, cause I lack of space in some areas in the pack.

Robert
 
Last edited by a moderator:
Mine all came from our local Radio Shack or electronics store, they are just various electronic connectors and switchs.
Lynn
 
Last edited by a moderator:
ANYONE WILLING TO HELP HERE???? I have the 2 XLR connectors installed already but need to know what the 3 other little buttons are and none on the photos on this thread work anymore! Can anyone tell me what parts they used from RS? Photos might help us out too.
 
If I were to go off of the photos shown here in the thread, I personally would use these switches - http://www.radioshack.com/product/index.jsp?productId=2062496&cp=&pg=1&origkw=push+button+switches&kw=push+button+switches&numProdsPerPage=20&parentPage=search

As for the switch on the far right, it's probably another push button switch, possibly a mini but has a metal cap instead of plastic like the other two. Like I said, these are my thoughts and could be way off base here. Hope this helps.

Rich

LynnsJet%20Pack.gif
 
what is everyone using for the trim at the top of the ESB and jango that goes across. It looks studded? its across the top but doesn't go over the flat bar thing. what is it and where can I get some?
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top