new patterson shin tool

stormtrooperguy

Sr Hunter
down with the resin, up with the found parts!

normal__MG_0283.JPG


:-D
 
not the most exciting showoff thread, but here you go:

normal__MG_0420.jpg


built using the brak's buddy tutorial. i sprayed the black on though, rather than using tape.

probably the most pointless update i've ever done to my suit, but i'm happy about it :)
 
Well that's weird. The popular Darth Flan kit I recently sold matched up perfectly with the found part; i.e. direct cast.

--edit, I never knew an "undersized" kit existed.
 
Last edited by a moderator:
Well that's weird. The popular Darth Flan kit I recently sold matched up perfectly with the found part; i.e. direct cast.

--edit, I never knew an "undersized" kit existed.


i actually think it was just cut too short at some point. this is a pretty unimpressive resin kit, which was what got me thinking about the real parts. i may try to get the stir stick at some point too.

the resin one i have matches up everywhere, but is about an inch and a quarter shorter than the measurements on the tutorial here.
 
Some smaller photography shops in the uk stock the paterson squeezee for less than you will pay on ebay :) I managed to get mine for £10.00 from a place in basingstoke, the stir stick was £4.00
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top