Need some dimensions for the expansion screws

A

Appolo_50

Guest
Does anyone have some good quality pics of an unpainted expansion screw from the gauntlets? I also need as many dimensions as I can get on it.

-Paul
 
The dimensions are a follows.
Overall Height: 0.495"
Width of Main Body (closed position): 0.348"
Overall Width (closed position): 0.615"
 
Last edited by a moderator:
I got those dimentions but it just doesn't look right when I draw it out. Also are there measurements for how thick the bottom "plate" is and the length and width of the screw ends that stick out?
 
See if these pics help, all of which come from my Gaunt page:

http://www.thedentedhelmet.com/bbt/gauntlet_details.htm

Expansion_Screw_Size.jpg


Expansion_Screw.jpg
RotJ_Screw.jpg
 
This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top