Need measurements for JP holes in the backplate

  1. #1
    OPPI's Avatar
    Member Since
    May 2002
    From
    Ft Myers, FL
    Posts
    577

    Need measurements for JP holes in the backplate

    Like the topic says.... Exactly where do the square/rectangular holes go for the JP straps??? I guess a measurement from the bottom of the plate would be best as that is where there is a straight surface as opposed to the rounded shoulder part..

    thanks for the help all
    dan

  2. #2

    Re: Need measurements for JP holes in the backplate

    Although someone could certainly figure out the exact size and locations of those holes,
    I think it depends more on your harness system as well as the size/weight of your jet pack.

    If you base the holes on pre-determined measurements, you might not end up with a
    comfy fit. Your harness straps could also end up putting excess strain on your backplate.

Similar Threads

  1. Holes on the rocket /Jet Pack
    By Madrid Boba in forum Boba Fett Costume
    Replies: 11
    Last Post: Nov 16, 2007, 11:26 AM
  2. Cutting Holes in Backplate for Jet Pack Straps:
    By Dha Syntir in forum Boba Fett Costume
    Replies: 4
    Last Post: Jan 21, 2007, 12:41 PM
  3. cutting holes for lights in alluminum ?
    By BH2372 in forum Boba Fett Costume
    Replies: 3
    Last Post: Aug 8, 2004, 11:52 AM
  4. Should I cut the Key holes out????
    By BFett88 in forum Boba Fett Helmet
    Replies: 5
    Last Post: Jul 18, 2004, 8:53 AM
  5. cutting out the key holes???
    By thksdad in forum Boba Fett Helmet
    Replies: 7
    Last Post: Jun 10, 2004, 12:35 PM
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •