need ESB flamethrower drawings

CombatBaby

Well-Known Hunter
planning to machine these

need more drawings.

can't find any good drawings using the search function

Does anyone have a set of drawings with semi accurate measurements?

all i have to go off of right now is a 2d static drawing with minimal measurements.

started a couple parts, but i'm unsure of the needed depth and diameter of some of the parts.

help will be appreciated

thanks

-CB
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top