General Neckseal issue when sewn to the jumpsuit

Darth Voorhees

Well-Known Hunter
Preferred Vendor
This is one of the pics form our photoshoot today....its the only one the photographer posted up so far....he has great equipment, as ytou can see, and the photograph is excellent...however, look at my neckseal. It sits fine until i put the vest on then it ends up bunched under the vest and i cant get it out. When i use a seperate neckseal, this doesnt happen. Anyone else have this problem with the neckseal sewn to the jumpsuit?

1606371_10202661785844393_77419246_o_zpsc52f0c01.jpg
 
Are you using magnets for the armor? It looks like I see a disk there. Maybe if you moved the disk closer to the top so it won't move so much. I think that if it is magnets are placed on the top most portion your flak and also on your flightsuit by the opening won't droop down. So it's armor> magnet >magnet>flak>magnet>magnet>flightsuit. don't know if I explained it correctly.


Sent from my iPhone
 
its actually bolts holding it on, what you see is the grommet on the vest.

I think I may just use the separate neck seal.
 
Last edited by a moderator:
i was thinking that as well Dom, but when i dont have the vest on it sits perfect. ..but the seperate one i have coming is a 17"...i THINK this one is a 19" so, it may very well be the problem...i'll test it when the new one arrives.
 
Last edited by a moderator:
haha..i measured my neck, its 17"..im gonna take the jumpsuit out and measure the neckseal sewn to it...that may very well be the issue. Worse case, i'll use the separate one i suppose.
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top