My FP armor progress

In my point of view i think the pieces of armors are a little smaller for you ? Or it used to be looked like that ? I'm not sure . Nice paintings anyway =]
 
Lich said:
In my point of view i think the pieces of armors are a little smaller for you ? Or it used to be looked like that ? I'm not sure . Nice paintings anyway =]

nope, they're about right on him. Any bigger and it would look weird.
 
Jango_Wes said:
I tried to do a blackwash. It turned out crappy. I used Pavespawn's paint and windshield washer solution but it didn't turn out well. So I went outside, wiped some brake dust off my car and put that on there. It shows up in person.


Wes

Be careful with the dust guys, that stuff will seriously shorten your life span if breathed in. If you want to weather your armour just use diluted (extremely diluted) black paint, sponge it on or air brush). Please though, stay away from the brake dust.
 
Looking good! I love the detail of your paint. Is this still being produced? I've PM'ed a few times but no answer and my X-Mas bonus is burning a hole in my pocket! Can anyone else help?
 
Ronin677 said:
Be careful with the dust guys, that stuff will seriously shorten your life span if breathed in. If you want to weather your armour just use diluted (extremely diluted) black paint, sponge it on or air brush). Please though, stay away from the brake dust.


Looking really good Wes - I think the colours look spot on. Your suit is looking mighty nice.

Most brake friction material has not contained asbestos (sp?) for a long time. however - I would agree not the best stuff to inhale...

Loranar
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top