measurements needed urgently

Ronin677

Well-Known Hunter
Hi guys, as the title says i need some measurements urgently. I really need them today before i leave work if possible.

the item i am trying to measure is shown in the pic below. its the small cover plate on the sides of the front spine on the JP (i think the pic is of a Bobamaker JP, hopefully Daz won't mind me using it).

thanks guys

JP_Rocket.jpg
 
Zombie - thats the kiddie. I just realised that i have bought all the paints for my scratch built and have missed this one item off the JP :eek:
 
For that piece I scaled up the overall jet pack on the grid line from WoF's Templates.

Just scale the pic up to where the squares are 1"x1" and then use the piece as a template.

Hint: I used Paint and the pics as downloaded and used the Page Setup feature under File Menu, then under scaling adjusted to 141% (or 140%can't really remember now), but it was one of the two

Hope this helps.
 
thanks for all the advise guys. I now have the pieces sorted. The next time you see this project i hope to have a 'few' layers of paint on it.

Wish me luck, i'm going in.
 
Sorry about not sending the drawing to you I got total swamped and lost track of a number of things. Glad you got what you needed.

Can't wait to see what you have.

Alan
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top