measure once cut twice... aww crap

fettenvy

Hunter
so I purchased one of tk409's chest light display things (is there an actual name for it?) and instead of putting 8mm b/w the upper and lower boxes, I put 4mm.

:cry

so, my armor is all fiberglass... what can I use to widen the 4mm gap to 8mm?

thanks

:cheers
 
How about a small strip of 1/8" sintra? That is about 3mm. Use a gel type super glue to set it and more glue or automotive spot putty over the seam and sand it smooth.

Or can you glue a piece of the fiberglass part back in??
 
I have used a dremel tool with a small high speed cutting bit. It works wonderful. Just becareful and take your time.

9901.jpg
 
I'd second the epoxy putty.
I've used it to correct cutting errors and to smooth out joints in poorly made components with acceptable success...
 
This thread is more than 18 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top