MADMARTIGAN'S ESB EE-3 BLASTER!

FettDad

Active Hunter
well, with the snow finally melting, and the air not being so humid, i was able to get Madmartigan's ESB blaster finished up! (y) he requested some rust in the nooks and crannies, so i obliged...(y) very pleased with how this one turned out...:cheers thanks brother for letting me be part of your "new and improved ESB Fett"! ;)

100_4908.JPG 100_4910.JPG 100_4909.JPG 100_4913.JPG 100_4912.JPG100_4914.JPG 100_4911.JPG
pencil.png
 
Last edited by a moderator:
Kudos on yet another amazing looking blaster. I think I need to save up to get you to do mine. I doubt very much I could do as good a job.
 
Very nice. Where can one get the square stock detail pieces that have the raised details inside them? I have seen these, but have not seen a resource for these. Would love to get these to upgrade my ESB Blaster.

Thanks,
Dave
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top