Looking for ROTJ blaster dimensions

Thread starter Arn Ma Brlou
Start date Jan 11, 2004

Arn Ma Brlou

Hunter

Jan 11, 2004

Hello Fetts et. al.,

I’d like to try to scratch build a ROTJ blaster. I’ve got a good line drawing I want to work from, but I need some measurements. Does anyone know the diameter of the piece with the little fins on it (the part between the chamber and barrel)?

Any other measurements would be helpful, too!

Thanks!
m@

This thread is more than 20 years old.

Your message may be considered spam for the following reasons:

This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.

If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.

I am aware that replying to this thread may be considered spam, but I still want to make a reply.