A Little Help Please

SNate

New Hunter
Ok, before anyone yells out to use the search, let it be known that I did. I have downloaded the Fett armor templates...do not recall the maker of the files right now.

I have two files. One of them is PDF format and the other opens a .gif in a web browser. I downloaded the medium set which was in the parameters for my height.

Now my problem is...how in the world do you print it the correct size? I have read the instructions that come with the files and searched for tuts on it. They all seem to be a little vague in the printing of the templates. Maybe it is something that I am overlooking or I am having one major bout of cerebral flatulence...

Can someone help me out and clarify the actual printing process please?

Thanks in advance!!

-Nate
 
The maker is most likely wizardofflight. Here is his armor template thread: http://www.thedentedhelmet.com/f25/updated-printable-armor-templates-various-sizes-7825/

You need to make sure when you go to print them that it is set to "fit to page" and they should print correctly. If you are using Acrobat Reader to print, on the print screen under Page Handling, you should see a "Page Scaling" drop box. Be sure it is set to "Fit to printer margins" and that it shows the file ad being 8.5x11 to the right. You also want to make sure that "Auto-Rotate and Center" has a check by it also.

Hope that helps.
 
Yes...actually that explains a lot!! Thank you. I will try it when I get home from work tomorrow morning and see how it goes.

Thanks again for the clarification!!
 
This thread is more than 13 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top