Subscribe
  1. Jedi-Bob's Avatar
    Member Since
    Mar 2002
    Posts
    1,570
    Nov 13, 2003, 6:47 PM - Left Gauntlet Flame-Thrower Construction Question #1

    I am about to finish up this piece and wanted to know if the inside of the FT (nozzle) should be painted prior to inserting the 2 nozzles.

    I was going to glue the 2 holed attachement in and then when it is all done and painted, just glue in the 2 nozzles.

    Sound right?

  2. Defiler's Avatar
    Member Since
    Nov 2002
    Posts
    1,092
    Nov 13, 2003, 8:21 PM - Re: Left Gauntlet Flame-Thrower Construction Question #2

    Hey JB, I assembled the nozzels on to the 2 hole support separate to make sure that they where glued the right way. Then I painted the inside of the flamethrower in aluminum and after it was dryed just attached the entire (painted and weathered) nozzel setup to the flamethrower housing. After that I just glued the bottom part of the flamethrower.

    I then painted the flamethrower covering the nozzels so that they would not get painted.

    I found it easyer to assemble the nozzel setup first.

    I hope I was of some help.
  3. Jedi-Bob's Avatar
    Member Since
    Mar 2002
    Posts
    1,570
    Nov 13, 2003, 9:46 PM - Re: Left Gauntlet Flame-Thrower Construction Question #3

    That is exactly what I was thinking.

    Thanks!

Similar Threads

  1. Need help with ESB Boba gauntlet flame-thrower.
    By Madrid Boba in forum Boba Fett Costume
    Replies: 0
    Last Post: Apr 16, 2008, 11:58 AM
  2. ESB GAUNTLET ALUMINUM FLAME THROWER
    By HMPOTC33 in forum Boba Fett Costume
    Replies: 4
    Last Post: Feb 14, 2007, 11:03 PM
  3. ESB Flame Thrower
    By Kissker in forum Boba Fett Costume
    Replies: 7
    Last Post: Jan 23, 2005, 7:13 PM
  4. ESB GAUNTLET FLAME THROWER
    By AKAI_FETT in forum Boba Fett Costume
    Replies: 7
    Last Post: Feb 19, 2004, 8:19 PM
  5. Gauntlet Assembly~ How are you installing the flame thrower?
    By BOUNTY HAUNTER in forum Boba Fett Costume
    Replies: 3
    Last Post: Jul 16, 2003, 4:33 PM