kukis armor build

thanks guys for all the encouraging comments, im still having troubles getting the back plate into shape, i shall print out the WOF backplate template and draw on the fold lines for the sides and try hammering them see if that helps the shape, ive had so much dramas with the backplate, i made one out of fibreglass a while ago and it didnt come out correct either.
 
well, made some new backplates out of 1.2mm ally this time, and managed to get one into shape, really need to start pulling my finger out and get this going again, have also started on the pepakura jet pack got the main body done, just having nightmare with all the cones


here is the backplate

Picture016.jpg
 
Gees kuki, are you aiming for antique armour? ha ha ha
Looking really good mate....I'll have to come around some time this weekend to have a peep at it.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top