JP to harness attatchment?

Just do what I am doing, bend some sheet metal to the shape and your good to go.

Basically, that is what they did to make em for the actual prop.

(I'm still working on my prop accurate harness..)
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top