Jet Pack beacon attachment

yodakiller1138

Well-Known Hunter
Jetpack beacon attachment

I have a jet pack beacon I want to attach to my jet pack. It has a 1/2- 13 thread on it. I want to find something that can attach it to the jet pack, but is hollow , so I can feed wires thru for the light. At one time it had a plastic piece that would have done this, but I have lost it over time. Anyone have any ideas or suggestions.

Thanks,
Scott:D
 
I might be able to give you a few suggestions... once I've had a chance to check out my local Home Depot that is. :D

Take a look in Home Depot down the fastener aisle, you know, the aisle with all the nails and screws. Go towards the end of the aisle, towards the back of the store, where the "specialty" fasteners are in those rotating towers. There you should be able to find hollow style screws and inserts, typically used for Ikea style furniture. (y)
 
Last edited by a moderator:
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top