Jet Pack Adjustment Knob

I took a picture of one of the found parts sitting next to TK7602's milled piece last weekend when Art brought it with him to our photo shoot. I'll post the picture up tonight so you can see it. TK7602 will have to say where the milled piece is from since I have no idea. My Russ Rep milled piece looks to be a bit different than his.
 
Last edited by a moderator:
I took a picture of one of the found parts sitting next to TK7602's milled piece last weekend when Art brought it with him to our photo shoot. I'll post the picture up tonight so you can see it. TK7602 will have to say where the milled piece is from since I have no idea. My Russ Rep milled piece looks to be a bit different than his.


my metal bits are all psberetta/serenity.

you were the one that took the dart photo right? couldn't remember if it was you or jeff.

either way i'm anxious to see them :)
 
Last edited by a moderator:
As you can see, the real one is larger than the psberetta/serenity machined piece. I wish I had thought to bring my pack to compare it to the Russ-Rep one.

n698862558_1387380_6849.jpg
 
Last edited by a moderator:
Question, can we get a comparison shot of the original piece next to the newer, thick base part? the tube appears thicker and shorter than the original, but that could just be tricksy photography

Shinobi
 
Last edited by a moderator:
Hey! Check this out... while combing for more info about this turntable, I stumbled across this... take a look at this picture! This is horizontal piece is a part from the shin tools! If I remember correct the "anti-security blade" the two rods taped together to the RC squeegee. Look for yourselves

shinobi

50f7_3.JPG
 
Last edited by a moderator:
Hey! Check this out... while combing for more info about this turntable, I stumbled across this... take a look at this picture! This is horizontal piece is a part from the shin tools! If I remember correct the "anti-security blade" the two rods taped together to the RC squeegee. Look for yourselves

shinobi

It's close, but not exact
there should be 2 indentations on the non-knurled end
discussed here
http://www.thedentedhelmet.com/showthread.php?t=25888&highlight=brush
 
Last edited by a moderator:
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top