INTEREST THREAD BEACONS JP STABILIZER

Hi guys thanksfor the interest looks like this is a go! Gonna try and find some pics! of my last run!! I wont be able to post pics of the 4 slots yet till they are finished!!!OK but the finish beacon will have 4 slots ok !! Soon as I have pics and prices I will post here then start a sign up thread ok... Beacons will have a little screw at the bottom like the knee darts so you can attach! Stabilizers can just be super glued as they have a nice flat bottom!! :)
Russ.
 
Hi guys thanksfor the interest looks like this is a go! Gonna try and find some pics! of my last run!! I wont be able to post pics of the 4 slots yet till they are finished!!!OK but the finish beacon will have 4 slots ok !! Soon as I have pics and prices I will post here then start a sign up thread ok... Beacons will have a little screw at the bottom like the knee darts so you can attach! Stabilizers can just be super glued as they have a nice flat bottom!! :)
Russ.


What will they be made out of?

I will probably want to drill a hole up to the slots, to insert wiring/light.

(will use a hollow screw/nut to attach to JP)

or - can you drill a hole that far up? for some extra credits?
 
i've got an older generation of his beacon. the one i have is hollow aluminum. the screw is set into the aluminum tube.

i have 1 hole in the JP for the led wires to go through, then a second hole nearby for the screw.

i'm not describing it all that well, but hopefully the point is getting across. ultimately, it is wire-friendly.

i want the stabilizer and the 4 slots though, hence me replacing the existing one :)
 
Yes they will be hollow so if you want you can put a light in there... And they will be machined from ALU.!!!
Russ.
 
Thanks sign up thread will be up in a few days. But psberetta vbmenu_register("postmenu_192120", true); Has just started the same project as well???
Thanks
Russ.
 
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top