Install a PVC frame inside your jet pack?

  • Thread starter Migrate from As You Wish
  • Start date
Small correction, you have a styrene Bradley jet pack not an ABS one. My oh my I would be so envious if anyone had an ABS jet pack.

Bob, at least you are way ahead of me in the progess of your jet pack. I'm still at the stage where I am epoxy-puttying the seams along the jp body.
 
Last edited by a moderator:
Jedi-Bob..... My first pack was a Bradley, I found no need to screw or glue the PVC tube in the main body...... mine fit REALLY snug in the body and with the PVC frame (If you choose to use one) installed, and the body cavity filled with the foam, it wasn't going or moving anywhere....
My .02.....
Lynn
 
Last edited by a moderator:
This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top