How do I get piping to to stick on scratch built boots

bradbucholtz

New Hunter
Ok guys, how the heck do I get the piping to stick on a pair of scratch built boots. TK409 mentions regular super glue, but let me tell you, that is just not working for me. Does anyone one else have some good tips?

Thanks in advance, Brad
 
i would recommend some kind of goop or 2 ton epoxy, but I used the 5 pack super glue from Wal-Mart for mine (99 cents). My scratchbuilt boots were a thin suede material ($3 Goodwill!!). It soaked up A LOT of super glue, but in the end it held. I will not lie and say it is permanent because it does pull off :(
 
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top