Gauntlet missile - help

DarthVader1

Well-Known Hunter
I have my gauntlets from S1, and it came with the resin missile unattached from the left gauntlet (for shipping purpose),nicely in bubble wrap. It has two little metal studs or pins underneath the missile to insert in the gauntlet holes.

Now, the question is: How can I attach this missile to the gauntlet, and is there a way that I could do that without doing it permanently so I could detach the missile for a future shipment or something? I was thinking about using a glue gun in the studs from the inside once the missile is installed to avoid skipping or movement, but that will be a permanent application. Any more ideas?
:confused


Robert
 
I'd considered either going with the glue or possibly threading the posts and using a nut to hold them in place. If something better comes along, just unscrew them. If the posts are removeable, take them out and run a few screws through the inside of the gauntlet up into the missle. That is how I did mine.
 
Thanks BF. Sounds like a great idea and I'll try to do that this week. But I think that the posts are permanently attached to them. I'll try to verify if they're removable. If so, I'll be looking for screws small enough that could fit in the litte holes as well as the post's gaps. I'll be posting my progress as soon as I find out.


Robert
 
This thread is more than 21 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top