FS: Accurate Chest and Shoulder Vinyl Decals/Stencils

Not sure if it was asked previously in this thread, but when it comes to "weathering", how do these hold up? I am assuming the process would be to apply to the helmet, chest plate, shoulder, jetpack, etc., after it is initially painted and prior to weathering. I am curious how someone goes about making these look beaten up, and less pristine...?
 
Not sure if it was asked previously in this thread, but when it comes to "weathering", how do these hold up? I am assuming the process would be to apply to the helmet, chest plate, shoulder, jetpack, etc., after it is initially painted and prior to weathering. I am curious how someone goes about making these look beaten up, and less pristine...?

Since the vinyl being used has a matte finish,it will actually take on any paint applied to them. Also, the vinyl is very pliable and can be cut, scratched and weathered very effectively. Yep, exactly. Apply to the armor after it's already painted, then weather it manually.
 
This thread is more than 10 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top