FP v2 knees ........help please

I'm working on my FP v2 armor, which is pretty straightforward up until I get to the knees. They are flat and need to be bent to fit around my knees. Anyone have some input as to the best way to accomplish this sans heat gun? Thanks in advance for the help.
 
Last edited by a moderator:
This thread is more than 15 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top