Forcebewitya's home made EE-3

Forcebewitya

Active Hunter
Hi everyone I'm still sort of new here but I thought I would post some progress pics of my Fett Blaster. The base revolver is a denix replica revolver so its real metal and feels like a real gun. (I'm probably going to regret this when trooping but for now its cool). And I'm going the PVC route, and sink piece for the barrel. The scope is a Daisy 6x9 scope for a BB gun and the stock is something I found at an Antique store. Still not sure I'm going to use the stock or make my own. My only main complaints so far is that I had to cut the bracket to make it fit my revolver so it juts upward instead of smoothly transitioning into the stock. and that the trigger is a bit smaller than the webly's Other than that what do you all think so far.

DSCN1872.jpg


goodone.jpg


secondupload.jpg


I'll continue updating this thread with pics as I put it together and paint. (I also have the greeblies.)

Forcebewitya.
 
Looking good. Only thing I'd suggest is the butt stock should be on the same side of the connector bracket as the pistol grip.

-Bill
 
ah good call. I guess I didnt think about it when I was taking the pic. but luckily I havent attached it yet so it's all good.

Forcebewitya.
 
This thread is more than 16 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top