Finished my Shin Tool Sculpts

bobamaker

Active Hunter
At last, a couple of months work on and off, and they are finally ready to mold. I used the Paterson squegee and stir stick and made sure that all the tools will show out of the top of the pockets to the correct height.

Copies of these will be ready for sale hopefully by January.

As always, our opinions are appreciated.

(If the tool on the left looks a little bent, it isn't, it's just the camera lens distorting it)

Shin_Tools.jpg


http://www.bobamaker.co.uk/
 
Very talented Those look awesome.

How is your helmet sculpt coming? WIll it be done by epIII? Cause I am waiting to get one from you.
 

cal196 wrote:

Very talented Those look awesome.

How is your helmet sculpt coming? WIll it be done by epIII? Cause I am waiting to get one from you.

It's coming along nice... I'm gonna be publishing some pics of work in progress pretty soon. It could well be finished for the time EIII is released, depends a lot on how busy I am with other stuff. Hang in there....
 
This thread is more than 19 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top