fettpride armor v3 collar/backplate overlap and collar studs

obi sean kenobi

Well-Known Hunter
Hi all,

For all you guys out there with fp v3 armor, how far does the collar overlap the back plate?

Also, I need measurements for the placement of the collar studs?

Help!

OSK
 
I'll take some measurements tonight, and snap some pics as well. I would think each persons dimensions would be slightly different, depending on their frame. If you make it too tight, the collar can choke you right at your adams apple....
 
I don't think there is a set size as Scott says. Chris left plenty of plastic on there that can be trimmed as and when required. Best thing to do is position it on your body/vest and mark where they naturally fall, then work to that and maybe trim off some if you have more than required to join the two. I think I ended up with about an inch, but can't remember if I trimmed any off to get to that?

Hope that helps.

Bobby.
 
I did NOT trim any material, if you look at the reference pics from MOM, there's actually a considerable amount of overlap from collar to back.
 
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top