Evolution Props Helmet REBUILD

All righty- I Quick Weathered this with some scrapes from an exacto, some course grit sand paper, charcoal and two layers of Matte Enamel With Thinner. Then I used testors matte dull coat cut with testors thinner (3 Dullcoat to 1 part thinner)
RNhekz2.jpg
(On the table with some ominous lighting)
yOicBFo.jpg
More (lighting)
BrFt0sj.jpg
Some kill stripes (Can use a little more silver damage over a section of the kill stripes) I'll fix that up when I get the ear caps and RF on
uiNdLy7.jpg
A little bit of the rump
The weathering wash really lightned the "mint" tone of the top and lower mandibles..
looking for an ear piece set with Aluminum stalk to finish it up...
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top