ESB stock greeblies

TANGOD FETT

New Hunter
Hi all I am looking into scratchbuilding some splitplugs and the square part for the ESB EE-3 ,I was wondering if anyone has any accurate dimensions or even better some plans for these parts :)

thanks in advance

Steve
 
Here is the split plug drawing in PDF format it should print out fine on standard 8.5X11 paper, but as a double check, the plug is 3" wide.

Post pics.

Alan

P.S. this would be a perfect project for laser cutting.
 

Attachments

  • ESB Stock Split Plug.pdf
    49.4 KB · Views: 461
This thread is more than 17 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top