Blaster ESB Recipe

Here's an update on the custom:

Video

A youtube video you say? Is it going to be a slideshow of progress pics perhaps? Ah hah ha ha ha haaaa... nothing so mundane. ;)

SAS
 
Oh my God!!!!!! I am absolutely speachless.... I have not been this shocked in a long time, theres not much that surprises me nowadays. Just wow, I dont know what else to say. Holy ****! Pm sent man!
 
Last edited by a moderator:
Here's some ESB progress X2, painting finished and awaiting final assembly and clear coat.
Also custom progress made; battery holder and wiring inserted in base of stock, grip area wired and and trigger activated switch installed & fake motor/belt drive attached to barrel. Still needs a custom side mount scope and one or two bits.

TR4059, anything you particularily fancy to greeb up the stock?

SAS

Custom fett EE3.jpg


ESBCustwip.JPG


ESBAFIN.JPG
 
Looks incredible!! I cant think of anything that would make it more awesome :lol: Whatever you decide for the stock is fine with me, I still cant get over the working barrel.
 
oh my, a ee-3 mini gun. noone should have that power!! sender on ova to me & ill throw it into Mount Doom for ya

what are the two different shades of black you use between the gun and scopemount setup?
also sent ya a pm SAS
 
Last edited by a moderator:
A bit more custom progress. Found the remnants of a working replica scope I had so used that - its kinda see through but image is small due to it having been chopped in the past.

SAS

customESBbarr.JPG


customESBbarr (1).JPG


customESBbarr (2).JPG
 
Painting done.

The EE-3x, an experimental rapid fire blaster designed for use against fast moving targets. Each blaster bolt carries less energy but the much higher rate of fire delivers more bolts on target per second than a standard rifle.
An auto target adjust is mounted on the left side.
Only a few prototypes were built due to problems such as overheating and power cells being rapidly drained.
This particular example has been modified to carry extra cells in the stock and has had cooling vanes added to the front barrel bearing area.

SAS

customESBdone.jpg


customESBdone (1).JPG


customESBdone (3).JPG


customESBdone (4).JPG


customESBdone (5).JPG
 
The real motor is actually inside the barrel near the back, the side mount is fake :) I just liked the idea of an external motor with belt drive.

SAS
 
This thread is more than 2 months old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top