esb fett blaster parts help

Megatron

Well-Known Hunter
looking at building a esb fett blaster.
what I need are measurements of the large triangle (2) ring mounts for the scope and the length and width of the barrel with out the flash
I have a resin cast Flare gun but it has no barrel (its for a ROTJ build)

am thinking a pvc or abs tube for the barrel

I can build the triangle mounts from flat stock plastic or if I have good measurements maybe make a 3d model and have shapeways print them

also looking for a leather sling and sling mounts
thank you
 
This thread is more than 10 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top