ESB correct sidearm interest topic

Yep sorry guys... been a tad busy?

But fingers crossed this Friday I shall have my sample set of Ali parts that have been measured using Micrometers and vernier calipers than CAD drawn by me to then run through the CNC process...
I'll post some pretty pics and I know I'm gonna get a loads of questions about costs :lol: please bear with me on this subject, but rest assured the Ali parts alone are very reasonable! ;)
Stay tuned for Friday...
 
Hey guys....

Well, I got my samples from the machinist and they look really nice! (IMO obviously) I've gotta pop out but will post some nice pics for you to drool over! :lol:
I do have a question for you all regarding the finish to these but this will become more apparent when you see the pics... (y)

Gav
 
This thread is more than 9 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top