Esb center greebile

It was mentioned that it could be a Myford Lathe switch box, either the 'on/off' push button or a 'forward/reverse' switch box. However searching through Myford switches hasn't turned up anything close.

I drew up a ruff cartoon of what I am interpreting of the B/W photo

Stockbox.jpg
 
Last edited by a moderator:
This thread is more than 14 years old.

Your message may be considered spam for the following reasons:

  1. This thread hasn't been active in some time. A new post in this thread might not contribute constructively to this discussion after so long.
If you wish to reply despite these issues, check the box below before replying.
Be aware that malicious compliance may result in more severe penalties.
Back
Top